Last night I finished up a small tool stand for my stakes and steel surfaces to rest upon.
I believe it is 30 inches tall and 34 inches wide. The top opening is 2 inches wide and the lower opening is 1 inch wide.
I believe it is 30 inches tall and 34 inches wide. The top opening is 2 inches wide and the lower opening is 1 inch wide.
The top rack is going to be used for my t stakes and my medium sized round spheres, and the smaller tooling fits on the small rack below.
I realized after putting my stakes on the rack that there isn't enough room for everything. I should have made it bigger, but highlight is a bitch and I am in constant learning mode doing these types of things since I have no formal woodworking education.
One thing I enjoy about this simple design is that it can be in constant flux. Ill more than likely be adding other racks and holders for specific items.
I realized after putting my stakes on the rack that there isn't enough room for everything. I should have made it bigger, but highlight is a bitch and I am in constant learning mode doing these types of things since I have no formal woodworking education.
One thing I enjoy about this simple design is that it can be in constant flux. Ill more than likely be adding other racks and holders for specific items.
RSS Feed
